Showing 1–8 of 57 results

AEMC CA7024 – Fault Mapper Model

  • Hand-held
  • Detects opens & shorts
  • Measure cable length up to 6000 ft (2000m)
  • Automatic cable impedance compensation

AEMC CA7027 – Fault Mapper Pro

  • Identify and locate faults on power & communication cables, given access to one end only
  • Measures cable length and indicates the length and distance to cable faults to a range of 9 ft (3 m) to 19,000 ft (6000m)
  • Works with virtually any type of cable

AEMC CA7028 – Wire Mapper Pro

  • Indicates all common wiring faults including split pairs, shorts, opens, reversed pairs and crossed wires
  • Unique graphical and digital display of fault information and length
  • Indicates distances to opens and shorts and identifies locations
  • Built-in tone generator for tracing and locating cables

AEMC DTR Model 8510 – Digital Transformer Ratiometer

Digital transformer ratiometer for on-site testing of power, potential, and current transformers. Measures primary to secondary turns ratio, polarity, and excitation current. Automatically self-calibrates and checks for open windings/connections/circuit breakers, short circuits (excess excitation current), incorrect test lead placement, and reverse polarity.

AEMC JM800 Series – AC Current Probes

  • Current output: up to 3000AAC (continuous cycle for the full temperature range)
  • designed for use on DMMs, power and harmonic, meters, recorders or instruments with AC current ranges

AEMC K Series – DC/AC MicroProbes

  • Measures extremely low level DC from 100uA
  • Outputs signal proportional to total current (DC+AC)
  • Low noise
  • Ultra-compact size and non-contact clamp-on convenience
  • Simple plug-in operation
  • Designed for use with digital multimeters and oscilloscopes
  • No range or mode (AC/DC) switching required
  • CE mark

AEMC LM Series – AC Current Probes

  • Clamping diameter 0.63″ (16mm)
  • Measurement range from 0.1 to 200 Amps
  • Over range up to 350 Amps continuous
  • 1ma/A output (model LM102)
  • 1mv/A output (model LM103)
  • Clothes pin design allows access to tight places
  • Frequency response from 48 to 10kHz
  • Arrow marker clearly assist in proper orientation for power measurement applications

AEMC MD Series – AC Current Probes

  • 600A range with mA or mV output
  • Unique hook-shaped jaws that enable the user to “pry” into or “hook” onto cables
  • Maximum conductor size is 2 x 500kcmil
  • Works as a traditional current transformer with ratio of 1000:1
  • AC/DC outputs available