• Megger

Megger® Model AVO3000

Digital Multimeters


  • Designed for electricians
  • Fully auto-ranging
  • Large display characters
  • Separate battery and fuse cover
  • Data hold
  • Min / Max store
  • IEC 61010 compliant
  • Suitable for applications to CATIII 600 V



Every measurement range is fully auto-ranging. Simply switch on the instrument and start testing, leaving hands free for holding probes, or hanging onto ladders. Separate Battery/Fuse compartmentThe battery and fuse compartment are accessed by a separate cover on the back. This allows both battery and fuses to be replaced without opening the main instrument body, and if the meter is sealed with a calibration seal, will not break the seal and invalidate the calibration. A problem found on most commonly available multi-meters.

Large clear display:


The LCD display has large high contrast 31/2 digit display which are easily read from a distance. Additionally the AVO310 has a backlit LCD for use in poor lighting and a bar graph range showing the percentage of range used.

Data HOLD:


This allows a displayed result to be held on the display until needed, rather than trying to remember a measurement. The result will be held until the HOLD button is pressed again, or until the unit switches off.

Fast 150 μs Audible Continuity Test:


The audible continuity test is a quick go/no-go test that distinguishes between an open and a closed circuit. The meter will give a continuous beep tone when the input resistance drops below 10 ½. This is useful for checking wiring connections and operation of switches.



When making current measurements the mode function allow the selection of AC or DC measurement. MAX/MIN (AVO310 only)The Max/Min function on the AVO310 freezes the maximum or minimum measured result on the screen. The display does not have to be continually watched to capture a momentary increase or fall in circuit voltage, resistance or current.

Voltage measurement:


Both AC and DC voltage measurement is possible with the instrument auto ranging to match the voltage at the test probes.Voltage measurements up to 1000V are permitted without damage to the instrument.

Current Measurement:


Three ranges are provided for current measurement of either AC or DC current from 0.1uA to 10A. Fused inputs protect both the user and the instrument in the case of excess current.

Resistance, continuity and Diode testing:


Resistance can be measured directly on the ohms range from 0ohms up to 1.999Mohms. A continuity buzzer range is also available for checking low resistance between two points. The buzzer sounding if the resistance is less than 50ohms (35ohms on the AVO310).Additionally a diode range exists for testing forward and reverse bias operation of transistors and diodes.

Additional features:


A low battery indicator warns when batteries are low, and an auto-off function ensures no unnecessary battery wastage occurs if accidentally left on.A built-in rear stand provides both a bench stand for comfortable use on the bench, as well as extending round 180° to act as a hanging bracket.


The AVO300 range of Megger digital multi-meters are tough compact instruments designed for the contracting electrician, but are also suitable for a wide range of applications and users. Both instruments offer a range of measurement modes for AC and DC applications, resistance and current measurement.

The AVO300 series multi-meters have tough rubber armoured cases offering the maximum amount of protection from the extreme use found in modern industrial environments. They draw on extensive experience of Megger engineers in designing safe reliable instruments for the electrical industry. Neither of the instruments are burdened with functions that never get used. This keeps the instruments simple to operate without the continued need to refer to the user manual.

IIII [+] Read More

Audible continuity Audible threshold:

AVO300: Less than10 ohm to 30 ohm Ω

Test current:

MAX. 0.3 mA AVO310: Less than 35 ohm Ω Test current MAX. 1.5 mA Overload protection: 1000 V DC or 1000 V AC RMS


Class2, Double insulation.

Overvoltage category:

(AVO300/310) CATIII 600V / CATII1000V


AVO300: 4000 counts LCD display, 25.4mm high AVO310: 4000 counts LCD display, 20mm high


AVO310 only Polarity Automatic, (-) negative polarity indication. Over-range “OL” mark indication.

Low battery indication:

A Battery symbol is displayed when the battery voltage drops below the operating level. Measurement rate 2 times per second nominal.

Auto power off:

AVO300: Meter automatically shuts down after approx. 15 minutes of inactivity. AVO310: Meter automatically shuts down after approx. 30 minutes of inactivity.

Operating environment:

-10 ºC to 50 ºC (14 ºF to 122 ºF) at < 70 % relative humidity.

Storage temperature:

-30 ºC to 60 ºC (-4 ºF to 140 ºF) at <80 % relative humidity.

Relative humidity:

90% (0ºC to 30ºC); 75%(30ºC to 40ºC); 45%(40ºC to 50ºC)


The instrument complies with EN61010-2-32


One 9 V battery , NEDA 1604, IEC 6F22


182 (H) x 82 (W) x55 (D) mm


approx. 375g

  • Literature
  • Specifications
pdf icon Description
++ AVO300 Series Specification sheet (1.6 MB)

Ranges & Accuracy

Technical Features
AVO300 AVO310
AC Voltage 1000 V 1000 V
DC Voltage 1000 V 1000 V
AC Current 10 A 10 A
DC Current 10 A 10 A
Resistance 0.1 Ω to 40 MΩ 0.1 Ω to 40 MΩ
Diode Test
Fast continuity buzzer
Tough Rubber Armoured
Auto power down
Battery Low Warning
Accuracy 1% 1%
Operating Temperature -10°C to +50°C -10°C to +50°C
Installation category 600V CATIII 600V CATIII
IEC 61010

Product Specifications

400.0 Ω 0.1 Ω +0.8% of rdg ±5 digits
4.000 kΩ 1 Ω +0.8% of rdg ±2 digits
40.00 kΩ 10 Ω
400.0 kΩ 100 Ω
4.000 MΩ 1 kΩ +3% of rdg ±8 digits
40.00 MΩ 10 kΩ
Input Protection: 1000 V d.c. or 1000 V a.c. rms.
DC Voltage (Auto-ranging)
400.0 mV 0.1 mV +0.5% of rdg ±2 digits
4.000 V 1 mV +0.8% of rdg ±2 digits
40.00 V 10 mV
400.0 V 100 mV
600 V 1 V +1% of rdg ±2 digits
Input Impedance: 7.8MΩ.Maximum Input: 1000 V d.c.
AC Voltage (Auto-ranging)
400.0 mV (AVO310 only) 0.1 mV +1% of rdg ±5 digits
4.000 V 1 mV
40.00 V 10 mV
400.0 V 100 mV
600 V 1 V +1.5% of rdg ±5 digits
Input Impedance: 7.8 MΩ.AC Response: 50Hz 60Hz Maximum Input: 1000 V rms
DC Current
400.0 μA 0.1 μA +1.0% of rdg ±3 digits
4000 μA 1 μA
40.00 mA 10 μA
400.0 mA 100 μA
10 A 10 mA +2.5% of rdg ± 3 digits
Overload Protection: 0.5 A / 1000 V and 10 A / 1000 V Fuse.Maximum Input: 4000 μA dc on μA range 400 mA dc on mA range 10 A dc on 10 A range.
AC Current
400.0 μA 0.1 μA +1.5% of rdg ±5 digits
4000 μA 1 μA
40.00 mA 10 μA
400.0 mA 100 μA
10 A 10 mA +3.0% of rdg ±5 digits
Overload Protection: 0.5 A / 1000 V and 10 A / 1000 V Fuse.AC Response: 50Hz to 400Hz Maximum Input: 4000 μA ac rms on μA 400 mA ac rms on mA 10 A ac rms on 10 A range.
Diode Test
0.3mA typical/Open <1.5 V(AVO300) 1 mV +10% of rdg ±5 digits
Open circuit voltage: 1.5 V dc typicalOverload protection: 1000 V d.c. or 1000 a.c. V rms
1mA typical/ Open MAX.3 V(AVO310) 1 mV +10% of rdg ±5 digits
Open circuit voltage: MAX. 3 V dcOverload protection: 1000 V d.c. or 100 V a.c. rms