| |
|
|
|
|
| |
|
| |
| |
 |
- The two 101 segment bargraph can be independently scaled.
- Bargraph center zero function.
- Four programmable setpoints.
- Relays activation can be selected to occur above (HI) or below
(LO) each setpoint.
- Decimal point setting.
|
|
|
| |
| |
|
|
|
| |
|
|
Smart dual-bar, dual-input or Single-input bargraph
with up to four fully programmable set points and an
isolated independently scalable 16-bit Analog output. |
|
|
| |
| |
|
|
|
|
| |
| |
- Two 10 Amp Form C, and two 5 Amp Form A relays available
- Auto-sensing AC/DC power supply. For voltages between
85-265 V AC / 95-370 V DC (PS1) or 15-48 V AC / 10-72 V DC (PS2).
- Optional isolated 16 bit analog output. User or factory scalable
to 4 to 20 mA, 0 to 20 mA or 0 to 10 V across any desired span
from ± one bar to the full scale range
- Provision to connect an external programming lockout switch.
- Optional NEMA-4 front cover.
- 24 V DC excitation is available to power external 4/20 mA
transmitters and 5 or 10 V DC excitation is available for
resistance bridge type sensors
- Dual input modes utilize the FL-B202Q specific
IDP4 Universal DC Volts, mA, 4-20mA dual-input
module
- Single Input modes are compatible with the
entire LEOPARD FAMILY: More than 38 different
Plug-in I-Series Input Signal Conditioners
|
|
| |
| |
|
|
| |
|
| |
|
| Display
|
| Bargraph: |
2 x 101 segment 4” vertical (std),
horizontal (optn), red (std), green (optn),
one red one green (opt) |
| Annunciators: |
4 red LEDs on front panel; one per setpoint. |
| Positive Overrange: |
Bargraph and top segments of digital
display flash. |
| Negative Overrange: |
First segment of bargraph and bottom
segments of digital display flash. |
| |
| A/D Converter: |
14 bit single slope |
| Accuracy: |
±(0.05% of reading + 2 counts) |
| Temp. Coeff.: |
100 ppm/°C (Typical) |
| Warm up time:: |
2 minutes. |
| Conversion Rate: |
10 conversions per second (Typical) |
| |
| Relay Output: |
Two 5 Amp Form A relays and Two
10 Amp Form C relays |
| Analog Output : |
Isolated 16 bit user scalable mA or V |
| OIC (mA out) |
4-20 mA @ 0 to 500Ω max loop resistance |
| OIV (volts out) |
0-10 V DC @ 500 Ω or higher resistance |
| Power Supply: |
AC/DC Auto sensing wide range supply |
| PS1 (std): |
85-265 VAC / 95-370 VDC @ 2.5W max 4.2W |
| PS2 |
15-48 VAC / 10-72 VDC @ 2.5W max 4.2W |
| General: |
| Operating Temp.: |
0 to 60 °C
|
| Storage Temp: |
–20 °C to 70 °C. |
| Relative Humidity: |
95% (non condensing) |
| Case Dimensions: |
3/32 DIN, Bezel: 36x144 mm(1.42”x5.69”)
Depth behind bezel: (4.64") 117.5 mm
Plus 10 mm (0.39”) for Right-angled connector,
or plus 18.3 mm (0.72”) for
Straight-thru connector, or plus 26.5 mm
(1.05”) for Push-On connector. |
| Weight: |
9.5 oz., 12 oz when packed |
|
|
| |
| |
|
|
|
|
| |
| |
General Specifcations |
|
|
|
|
|
 |
| |
Related urls: |
|
|
| |
- Model BL-40, 96x24mm Low Profile, 4 Digit, Digital Relay Meters
- Model BL-40F, 96x24mm
4 Digit, Frequency Digital Relay Meters
- Model BL-40H, 96x24mm
4 Digit, Temperature Digital Relay Meters
- Model BL-40PSF, 96x24mm
4 Digit, Scale Factor Digital Relay Meters
- Model BL-40RPM, 96x24mm
4 Digit, RPM Digital Relay Meters
- Model BL-B51D40, 24x96mm
51 LED Segment and 4 Digit Bargraph
- Model DL-40, 1/8 DIN
4 Digit, Digital Relay Panel Meters
- Model DL-40F, 1/8 DIN, 4 Digit,
Temperature Digital Relay Meters
- Model DL-40H, 1/8 DIN, 4 Digit,
Temperature Digital Relay Meters
- Model DL-40PSF, 1/8 DIN,
4 Digit, Scale Factor Digital Panel Meters
- Model DL-40RPM, 1/8 DIN,
4 Digit, RPM Digital Relay Meters
- Model FL-B101D40, 9/64 DIN,
101 Segment, 4 Digit 0.32” High LEDs
- Model FL-B101D40F, 9/64 DIN,
101 Segment, 4 Digit Frequency Bargraph
- Model FL-B101D40H, 9/64 DIN,
101 Segment, 4 Digit Temp. Bargraph
- Model FL-B101D40PS, 9/64 DIN,
101 Seg. , 4 Dgt Scale Factor Bargraph
- Model FL-B101Q, 3/32 DIN,
101 Segment Bargraph Relay Meters
- Model FL-B202Q, 3/32 DIN,
2 x 101 Segment Bargraph Relay Meters
- Model PL-B101D40, 3/32 DIN,
101 Segment Bargraph Relay Meters
|
| |
|
|
|
|
|
|
|